Technical parameters
| Item | Unit | Technical data | ||
| Max. clamping force | KN | 4800 | ||
| Max. opening force | mm | 770 | ||
| Space between tie bars | mm | 760×760 | ||
| Mould height | mm | 280-790 | ||
| Max. daylight | mm | 1560 | ||
| Ejector force | KN | 113.4 | ||
| Ejector stroke | mm | 195 | ||
| Ejector quantity | 13 | |||
| Screw diameter | mm | 70 | 75 | 80 |
| Screw L/D ratio | L/D | 22.6 | 21 | 19.7 |
| Theoretical shot volume | cm3 | 1346 | 1545 | 1758 |
| Plasticising weight(PS) | g | 1225 | 1406 | 1600 |
| Injection pressure | Mpa | 201 | 175 | 154 |
| Theoretical injection rate(PS) | g | 370 | 423 | 484 |
| Plasticising capacity(PS) | g/s | 60.4 | 71.4 | 83.7 |
| Screw torque | N.m | 3490 | ||
| Max. screw rotate speed | r/min | 150 | ||
| Injection stroke | mm | 350 | ||
| Carriage push force | KN | 120.6 | ||
| Pump motor power | KW | 45 | ||
| Pump pressure | Mpa | 16 | ||
| Heating power | KW | 28 | ||
| Heating zone | 5 | |||
| dimensions | m | 7.5×2.1×2.45 | ||
| Net weight | t | 20 | ||
| International designation | 4800-2710 | |||
Characteristic:
Vertical die locking. Vertical injection.Small footprint ,smart and precise ,suitable for injection molding of small and medium sized embedded parts.
Double cylinder injection system ,high injection pressure ,speed fast, thin molding best choice.
Direct pressure mode locking , stress distribution, low voltage protection fine Atoll, the whole process is fluency and execllent.
According to the characteristics of embedded parts and capacity requirements, it is equipped with skateboards and turntabie type machines to achieve the goal of minimum input and maximum output.
Scalable programming ,and self-embedded,take out equipment connections, to achieve
full self-operation.
Servo series Low consumption and environment-friendly:
1). Economizing on electricity: Electric motor energy is carried out according to need. For high-precision products with long holding time and thick wall thickness, energy electricity can be economized 25%-80%.
2). Precision: Products re-precision is once higher than usual injection molding machine.
3). Control: Double closed circular control makes the pressure and speed equaler.
4). Economizing on water: The cooling water can be economized greatly when the surrounding temperature is below 30 degrees.
5). Low noise: The noise is very low during the non-high-pressure situation.